Rokasgrāmata Philips BT1005 Bārdas mašīna

Rokasgrāmata

- Always check the appliance before you use it. Do not

use the appliance if it is damaged, as this may cause

injury. Always replace a damaged part with one of

the original type.

Caution

- This appliance is not washable. Never immerse the

appliance in water and do not rinse it under the

tap (Fig. 1).

- Only use this appliance for its intended purpose

as shown in the user manual.

- For hygienic reasons, the appliance should only be

used by one person.

- Never use compressed air, scouring pads, abrasive

cleaning agents or aggressive liquids such as petrol

or acetone to clean the appliance.

- Only operate the appliance on 1.5V LR6 AA

batteries.

- Use and store the appliance at a temperature

between 15°C and 35°C.

- Do not expose the appliance to direct sunlight.

- Remove batteries from the appliance if you are not

going to use it for some time.

Electromagnetic elds (EMF)

- This Philips appliance complies with all applicable

standards and regulations regarding exposure to

electromagnetic elds.

General

- Maximum noise level: Lc = 75dB(A)

Preparing for use

Placing the batteries

1 Open the battery holder and put the batteries into

the battery holder. (Fig. 2)

Make sure your hands are dry when inserting

the batteries.

Make sure the + and - poles of the batteries point in the

right direction.

2 Close the battery holder.

Using the appliance

When you trim for the rst time, be careful and test the

appliance on a small part of your arm or leg. Do not

move the trimmer too fast, make smooth and gentle

movements.

Trimming with comb

1 Slide the comb to the desired hair length (Fig. 3).

The hair length in millimeters appears in the window in

the centre of the comb.

Note: When you trim for the rst time, start at the highest

length setting to familiarise yourself with the appliance.

2 Switch on the appliance.

ENGLISH

Introduction

Congratulations on your purchase and welcome to

Philips! To fully benet from the support that Philips

offers, register your product at www.philips.com/

welcome.

Important safety information

Read this important information carefully before you use

the appliance and its accessories and save it for future

reference. The accessories supplied may vary for different

products.

Warning

- This appliance can be used by children aged from

8 years and above and persons with reduced

physical, sensory or mental capabilities or lack of

experience and knowledge if they have been given

supervision or instruction concerning use of the

appliance in a safe way and understand the hazards

involved.

Children shall not play with the appliance. Cleaning

and user maintenance shall not be made by children

without supervision.

3 Place the trimmer on the skin.

4 Move the trimmer slowly over the skin against

the direction of the hair growth while pressing it

lightly (Fig. 4).

Make sure the at surface of the comb always stays in

contact with the skin.

If a lot of hair has accumulated in the comb:

1 Make sure the appliance is switched off.

2 Slide the comb to the highest setting and

pull it off the appliance (Fig. 5).

Never pull off the comb at the exible top part, always

pull it off at the bottom part.

3 Blow and/or shake the hairs out of the comb (Fig. 6).

Trimming without comb

Use the trimmer without comb to trim full bears and

single hairs.

Note: The comb keeps the cutting unit at a certain distance

from the skin. If you use the trimmer without comb, the hair

will be cut off at the point where the cutting unit touches

the hair.

1 Switch on the appliance.

2 Make well-controlled movements. Touch the hair

lightly with the trimmer. (Fig. 7)

Cleaning

Never use compressed air, scouring pads, abrasive

cleaning agents or aggressive liquids such as petrol

or acetone to clean the appliance.

1 Switch off the appliance.

2 If the comb is on the appliance, pull it off.

3 Flip the cutting unit open.

4 Clean the cutting unit and the hair chamber with

the brush supplied. (Fig. 8)

5 Close the cutting unit by pushing it back onto the

appliance (‘click’).

Replacement

If the cutting unit is damaged or worn, always replace it

with the original Philips cutting unit.

1 Flip the cutting unit open.

2 Remove the old cutting unit by pulling it upwards.

3 Place the two lugs of the new cutting unit into the

guiding slots. (Fig. 9)

4 Push the cutting unit onto the appliance

(‘click’) (Fig. 10).

4222.002.8634.1

BT1005, BT1000

Register your product and get support at

www.philips.com/welcome

1

1

2

2

1

2

1,5

3

5

7

3

4

15

3

5

7

1

2

5 6

7

1

2

8

9

10

11 12

Vērtējums

Vairāk par šo rokasgrāmatu

Mēs saprotam, ka ir patīkami, ka jūsu Philips BT1005 Bārdas mašīna ir papīra rokasgrāmata. Jūs vienmēr varat lejupielādēt rokasgrāmatu no mūsu vietnes un pats to izdrukāt. Ja vēlaties saņemt oriģinālo rokasgrāmatu, iesakām sazināties ar Philips. Viņi varētu nodrošināt oriģinālu rokasgrāmatu. Vai meklējat sava Philips BT1005 Bārdas mašīna rokasgrāmatu citā valodā? Izvēlieties vēlamo valodu mūsu mājaslapā un meklējiet modeļa numuru, lai redzētu, vai tas ir pieejams.

Specifikācijas

Visas rokasgrāmatas par Philips Bārdas mašīnas
Citas Bārdas mašīnas rokasgrāmatas

Bieži uzdotie jautājumi par Philips BT1005 Bārdas mašīna

Mūsu atbalsta komanda meklē noderīgu informāciju par produktu un atbild uz bieži uzdotajiem jautājumiem. Ja atrodat ko nepareizu bieži uzdotajos jautājumos, informējiet mūs, izmantojot saziņas veidlapu.