Rokasgrāmata Philips SCD465 Bērnu monitors

Rokasgrāmata

It takes at least 14 hours to charge the batteries fully.

When the batteries are fully charged, the charging light gradually dims. You can then take the

parent unit out of the charger.

When the power-on light of the parent unit blinks red, the batteries are low. Put the parent unit

in the charger to recharge the batteries.



1

Place the two units in the same room to test the connection. (Fig. 6)

Make sure the baby unit is at least 1 metre/3 feet away from the parent unit.

2 Press the on/off button to switch on the baby unit. (Fig. 7)

The power-on light starts to burn green.

3 Turn the volume control to switch on the parent unit and to set the volume to the level you

prefer. (Fig. 8)

The power-on light starts to burn green.

When a connection has been established between the units, the connection light on the

parent unit starts to burn green.

Note:It takes about 30 seconds before a connection is established.

4 Place the baby unit at least 1 metre/3 feet away from your baby. (Fig. 9)

5 Position the parent unit within the operating range of the baby unit. Make sure it is at least 1

metre/3 feet away from the baby unit. For more information on the operating range, see

section ‘Operating range’ below. (Fig. 10)

Operating range

The operating range of the baby monitor is 200 metres/600 feet in open air. Depending on the

surroundings and other disturbing factors, this range may be smaller.

Dry materials Material thickness Loss of range

Wood, plaster, plaster cardboard, glass

(without metal, wires or lead)

<30cm/12in 0-10%

Brick, plywood <30cm/12in 5-35%

Reinforced concrete <30cm/12in 30-100%

Metal grilles or bars

<1cm/0.4in 90-100%

Metal or aluminium sheets <1cm/0.4in 100%

For wet and moist materials, the range loss may be up to 100%.

Features



Always make sure that the channel selectors inside the battery compartments of both units are set

to the same channel. With these channel selectors, you can select sixteen different channel positions.

If you experience interference from other baby monitors, radio devices, etc. select a different

channel.

1 Open the battery compartment lids of both units.

Parent unit: turn the locking knob in the bottom a quarter turn (1) and slide the battery

compartment lid downwards to remove it (2). (Fig. 11)

Baby unit: turn the locking knob with a coin and remove the lid. (Fig. 12)

-

-

-

,

,

,

,

,

ENGLISH8

4222.002.6422.1.indd 8 14-04-2006 08:51:54

Vērtējums

Vairāk par šo rokasgrāmatu

Mēs saprotam, ka ir patīkami, ka jūsu Philips SCD465 Bērnu monitors ir papīra rokasgrāmata. Jūs vienmēr varat lejupielādēt rokasgrāmatu no mūsu vietnes un pats to izdrukāt. Ja vēlaties saņemt oriģinālo rokasgrāmatu, iesakām sazināties ar Philips. Viņi varētu nodrošināt oriģinālu rokasgrāmatu. Vai meklējat sava Philips SCD465 Bērnu monitors rokasgrāmatu citā valodā? Izvēlieties vēlamo valodu mūsu mājaslapā un meklējiet modeļa numuru, lai redzētu, vai tas ir pieejams.

Specifikācijas

Visas rokasgrāmatas par Philips Bērnu monitori
Citas Bērnu monitori rokasgrāmatas

Bieži uzdotie jautājumi par Philips SCD465 Bērnu monitors

Mūsu atbalsta komanda meklē noderīgu informāciju par produktu un atbild uz bieži uzdotajiem jautājumiem. Ja atrodat ko nepareizu bieži uzdotajos jautājumos, informējiet mūs, izmantojot saziņas veidlapu.

Saistītie produkti

Rokasgrāmata

Philips SCD833 Avent Bērnu monitors

Rokasgrāmata

Philips SCD711 Avent Bērnu monitors

Rokasgrāmata

Philips SCD499 Avent Bērnu monitors

Rokasgrāmata

Philips SCD469 Bērnu monitors

Rokasgrāmata

Philips SCD361 Bērnu monitors

Rokasgrāmata

Philips SCD831 Avent Bērnu monitors

Rokasgrāmata

Philips SCD463 Bērnu monitors

Rokasgrāmata

Philips SCX465 Bērnu monitors

Saistītās kategorijas